Timer-comutator control rods

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2013: Timer-comutator control rods
Top of pagePrevious messageNext messageBottom of page Link to this message  By paul griesse--Granville,Ohio on Wednesday, January 23, 2013 - 10:29 am:

After screwing around for 20 minutes trying to bend an old control rod into the right shape for setting the timer I found a new rod I had ordered from Snyders which comes "pre-bent". Its almost a perfect fit! For $3.95 its a good investment instead of attempting to use the old rods which, at least on my Ts, are usually a hassle to try to refit.Hope this helps...Paul


Top of pagePrevious messageNext messageBottom of page Link to this message  By Charlie B actually in Toms River N.J. on Wednesday, January 23, 2013 - 10:38 am:

The best bender I've ever found is a small crescent wrench with the jaws tightly against the rod. The wrench is at a 90 deg. angle to the rod and a screwdriver through the hole in the wrench end for leverage. Let's twist again.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Jay - In Northern California on Wednesday, January 23, 2013 - 11:21 am:

This set of bending tools makes the job of shaping control rods a breeze. You can find them for sale from a number of Model T vendors for under $20.


Top of pagePrevious messageNext messageBottom of page Link to this message  By John B Joyce on Wednesday, January 23, 2013 - 01:13 pm:

Paul, Before you put on the new one use it as a pattern to reshape the old one. I'll only charge you $3.95 for this advice. Won't see you Friday as I'm going to Florida to scare some quail, The kind with feathers. John


Top of pagePrevious messageNext messageBottom of page Link to this message  By paul griesse--Granville,Ohio on Wednesday, January 23, 2013 - 02:22 pm:

Ok, John-----how about only $2? have a great trip! paul


Top of pagePrevious messageNext messageBottom of page Link to this message  By John F. Regan on Wednesday, January 23, 2013 - 02:24 pm:

If you start with a new rod and it is made correctly then only bend the rod in the "upper arc" portion above the timer. Just open or close that arc to retard or advance the timing. If the other end is hitting the radiator hose then the hose is too long since that rod is supposed to pass under the metal tube only and not the end of the hose and its clamp. That lower hose is supplied too long and if the timer rod passes under the end of that hose it will hit and limit the travel of the rod. Many people unfortunately start bending down there a that end to gain clearance around the hose rather than shortening the hose and moving the clamp. The upper hose is plenty long enough to make up the difference in overall length needed for the radiator connection.


Posting is currently disabled in this topic. Contact your discussion moderator for more information.
Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration