320 lift Stipe cam installation

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2013: 320 lift Stipe cam installation
Top of pagePrevious messageNext messageBottom of page Link to this message  By Mike Bender Tulsa Oklahoma on Thursday, January 24, 2013 - 11:01 pm:

The cam's front and middle bearing are 1.438" od, the rear runs in the 1" bore of the block. I needed to make the boring jig to open the Ford bores for fit. Also the block bores need to be notch for the cam lobes to pass. Lots of work. This how I skinned the cat anyhow. Thought some of you may be interested.




Top of pagePrevious messageNext messageBottom of page Link to this message  By Les Schubert on Thursday, January 24, 2013 - 11:06 pm:

Mike
How are you planning to control cam end thrust. I assume off the front cover


Top of pagePrevious messageNext messageBottom of page Link to this message  By Mike Bender Tulsa Oklahoma on Thursday, January 24, 2013 - 11:14 pm:

Bosh front plate. This engine will be a twin fire Rajo BB. I don't have a good email for LS but will get in touch with him tomorrow.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Les Schubert on Thursday, January 24, 2013 - 11:17 pm:

OK so now I am curious as to what you are using for the distributor for the dual plug.
I had contemplated using a e-timer and firing off both ends of the high tension winding of the coil.


Posting is currently disabled in this topic. Contact your discussion moderator for more information.
Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration