|
|
|
By Tom Butterworth on Tuesday, October 12, 2010 - 04:45 pm:This is a race car Im working on now .
By Tom Butterworth on Tuesday, October 12, 2010 - 04:51 pm:Ok I going to try this one more time aaahhhh!
By John Faccin - Crystal Falls, Michigan on Tuesday, October 12, 2010 - 05:10 pm:WOW WAY COOL!!!!! 
By Randall Strickland- Lambsburg,Va on Tuesday, October 12, 2010 - 06:59 pm:NICE!
By Dave Hjortnaes, Men Falls,WI on Tuesday, October 12, 2010 - 08:31 pm:Lookin good.
By tyrone thomas on Tuesday, October 12, 2010 - 10:32 pm:Tom I see you are incorperating a Model A steering box and collum. Can you give me details of what all you have done? Im building a speedster with the A steering but have not began to engineer it yet. Thank you.
By Verne Shirk on Tuesday, October 12, 2010 - 10:37 pm:Outstanding!!! Did you fabricate the body?
By Scott Gilham on Tuesday, October 12, 2010 - 11:18 pm:Very Nice Tom!!
And I'm with Tyrone, I'd like details on what you've done with the steering?
By Tom Butterworth on Wednesday, October 13, 2010 - 06:08 am:The steering column is an A 2 tooth . I did not use the tube of the column but used a round tube and machined a flange that sits against the inside of the firewall .I then bushed the tube to fit the steering column shaft . I also used Model A steering arms and tie rod which I had to add about an 1 1/2 inches . I made the body out of 20 guage steel with a wire edge rolled around the cockpit area . I will try to get a better picture of the steering set up .
By Tom Butterworth on Wednesday, October 13, 2010 - 06:36 am:Here is the steering up close .
|
|