Someone contacted me two months ago about a D O Frontenac manifold hanging from the rafters in the upper left hand corner. See picture below and contact me with more information, thanks, Fast Frank.
I have taken measurements and here they are. Intake ports on block are 1.75" and the carburetor mount is 1.875". See pictures below. Note: there is a welding repair at the intake port most likely to enlarge it to 1.875".
Two photographs showing inside and outside of manifold . . . scroll down
bump
It was me Frank
Need an original for my DO engine. Sent you a private message
Mark Herdman
Mark,,,,I've been tryin to email you,,,,contact me about the castings,,,
Thanks, DanPrice
Dan
Got the castings thanks and have sent you lots of emails but they are not getting through to you. Tried to call you today. Cant get trough. Just got back from trip south.
Thanks Dan
Mark
Dan - would you private message me, please?
Thank you
John Oder