After reading about the Scat crank and its wrinkle I wonder who's running Bill Dubat's crankshaft? What's your experience? They are 100% USA made.
I am running two of them. Bill did a good job. No problems with installation or running.
I bought one this summer, but haven't (needed to) installed it yet. I was following the Scat thread too, wondering if there would be a problem. It will either end up in our 13 or 09 engine.
Rob
I also have Dubats that is going in my stemwinding '20.
My BD crank is working great and went in with no mods or issues. Earlier this year did a new top speed with top up at 68 MPH. Runs real smooth.
What vendors sell the BD crank?
Here is one vender, I don't know about others:
http://www.modeltford.com/item/3030.aspx
Jim
Snyders have the same description for a crankshaft they sell. They also sell the Scat crank. Interestingly, they use the same illustration for both.
Allan from down under.