|
|
|
By kenny on Monday, January 21, 2013 - 06:40 pm:i have 1924 fordor do i need engine pan arm wood and where do they go 2 of them.
By john kuehn on Monday, January 21, 2013 - 06:48 pm:They go between the frame and the pan arm. Its best to have them in place as Ford intended.
By Larry Smith on Tuesday, January 22, 2013 - 09:40 am:There should be a little drag on them when you install them. I usually use a sawed off broom handle to pound them in, and then center them with a taper punch. I believe by '24 they were using the square ones, not the earlier style.
By Chris Barker, Somerset, England on Tuesday, January 22, 2013 - 10:32 am:.....and DON'T tighten the horizontal bolt which passes through them; just nip it up. This was Ford's recommendation to lessen the incidence of cracking and breakage of the arms. Use a self-locking nut unless you really think you can insert a split pin down in that narrow hole!
By kenny on Tuesday, January 22, 2013 - 11:48 am:Where do they go or where can I get a picture of placement .
By Dan Treace, North FL on Tuesday, January 22, 2013 - 12:02 pm:Between the crankcase arms and the inner frame rail.
|
|