Greetings all,
It's time to begin getting my T roadworthy and first order of business is an engine rebuild. I am in Chicagoland and would like to find someone who does quality work at a reasonable cost. I don't mind paying for good value - I'm not trying to get by on the cheap.
I'm looking for recommendations. Thanks
David
For exceptional work quality with great people,call J and M Machine Co in Mass!!I had them do my block for me and very satisfied,will answer any questions you have with your project.First rate job.
Ron Miller in Shandon,OH and Jack Putnam in Bluffton,OH. Both do quality work.
Rick
http://effingham-regrinding.com/
No personal experience but this shop was recommended in a post on this forum a few months ago. Check 'em out.
I send my work up to J and M Machine now because I have gotten one too many times by the so called "experts".
"BURNED" one too many times by the so called experts....
I cast my vote for Ron's Machine Shop in Shandon, OH. Good people who do good work. I have an engine/trans down there right now for rebuilding and customizing. From Chi-town it is an easy drive down I-65 to Indy and over I-74 to Shandon (northwest side of Cincinatti, OH). While you're at it, take a buzz up to Richmond, IN a little north of there to check out the MTFCA museum. Really cool!
Call Dave Szumowski at 773-502-1935. His dad is the person who rebuilds magneto pickup coils. Dave works out of his dads garage near Midway Airport. Dave does good work, is timely, and is near you.
Check out Joe Bell, also in Ohio.