'25 Tudor How to remove glass from the rear?

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2013: '25 Tudor How to remove glass from the rear?
Top of pagePrevious messageNext messageBottom of page Link to this message  By David Lorenzen on Saturday, July 13, 2013 - 10:09 pm:

How do you remove the original glass from the rear window? I am going to instal a new tempered glass window but need to remove the old one first. I am not talking about the glass in the back of the Tudor. The rear glass with the window regulators in the back is what I am trying to remove. If you could assist me with a few steps it would be much appreciated. Thank you.


Top of pagePrevious messageNext messageBottom of page Link to this message  By David Lorenzen on Saturday, July 13, 2013 - 10:11 pm:

Would I remove the window from the bottom, or does it remove out of the top (as if the window was rolled up)? Also, would I need to remove the window regulator first, or should I remove it after? If I have to, I will break the window and remove the broken glass. But I would prefer not to do so.
Thanks again :-)


Top of pagePrevious messageNext messageBottom of page Link to this message  By Jack Daron - Brownsburg IN on Saturday, July 13, 2013 - 10:27 pm:

Take off inside trim,remove window regulator and remove glass by tilting it inward.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Jack Daron - Brownsburg IN on Saturday, July 13, 2013 - 10:32 pm:

Take off inside trim,remove window regulator and remove glass by tilting it inward.


Top of pagePrevious messageNext messageBottom of page Link to this message  By David Lorenzen on Saturday, July 13, 2013 - 10:32 pm:

Thank you, Mr. Jack Daron, I will give it a shot right now.


Top of pagePrevious messageNext messageBottom of page Link to this message  By David Lorenzen on Saturday, July 13, 2013 - 11:08 pm:

Here is an update. I removed the regulator carefully and then lifted the window up towards the ceiling. Once it was high enough I started to lean the glass towards the inside of the cab. It was a very easy job so thank you very much.


Top of pagePrevious messageNext messageBottom of page Link to this message  By A. Gustaf Bryngelson on Saturday, July 13, 2013 - 11:32 pm:

I probably would have used a brick:-)


Posting is currently disabled in this topic. Contact your discussion moderator for more information.
Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration