I picked up 4 carbs today, and am looking for opinions on each, in terms of ease of use, power, looks and etc.
They'll be on a stock '23 ish engine.
Kingston model "L"
Kingston "L-4" Has a repair where the idle needle threads in.
Holley "NM" This was on the engine used by the seller.
and my favorite,
Tillotson Model "C *something*-3-A"
Cheers!
chriso
Look again at that Holley. Are you sure it says "NM", or is it NH? I did a search for Holley NM, and found zilch.
Steve - That must be a New Mexico carb instead of a New Hampshire carb
I hear it only works with tequila .
Four carbs on a std engine would be a bit much
You'll need at least a OHV head to use all that air & gas..
I don't know one from the other but, I sure do like my Kingston L4.
The Kingston L4 works fine on my car. If it needs a new throttle shaft, with a little work the NH throttle shaft will work.