My stock of good cams are dwindling, so need to know if any of you who know a thing or too about cam grinds, if this is one you would consider serviceable? I bought it several years ago and never liked the look of it, so shelved it.
The heels of the lobes are ground at least 32thou into the diameter of the cam shaft and I think the lift may fall short of a standard cam as well, will need to measure that later, what are you thoughts?
When I had a couple of camshafts reground to get 0.260 lift, the heel is below the body of the shaft. I suspect your camshaft has been reground.