Can you tell me what is the best way to change Bushings in cast iron pistons
Pictures tell me more as thousand words !!!
Toon
Here is a past thread:
http://www.mtfca.com/discus/messages/118802/159291.html?1284089400
Using aluminum pistons would be easier on you and the engine.
Jim
This afternoon I made a puller for the Piston bushings and works fine.
Toon
Is there anyone out there that wants the old iron pistons that I am removing from my engines?
Dave,
What size are they??
Andre
Belgium
Mike Walker was looking for some .020 - .025 overs, I believe.
Andre - they are standard from one engine. I have not looked at the ones from the other engine. It is too cold out there right now to check.
I'd like to get a set for a cut away engine I am doing, but I live too far away.