How To Tell What Year(s) a Frame Is?

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Classifieds: How To Tell What Year(s) a Frame Is?
Top of pagePrevious messageNext messageBottom of page Link to this message  By Bill Everett on Friday, June 23, 2017 - 10:40 am:

Fairly recently, a post listed the characteristics which identified the year(s) a frame was.

I'd appreciate it if you could link me to it.

Thanks.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Bill Everett on Friday, June 23, 2017 - 11:46 am:

btt


Top of pagePrevious messageNext messageBottom of page Link to this message  By Ernie Spittler on Friday, June 23, 2017 - 01:28 pm:

Is this it?http://www.mtfca.com/discus/messages/708324/752215.html?1494023904


Top of pagePrevious messageNext messageBottom of page Link to this message  By Perry Goble on Friday, June 23, 2017 - 01:40 pm:

The basic frame difference in the frames are as fallows . #1 09 to 1912 characteristics The back cross member looks like the front cross member in that it does not have the rear finder supports . The frame has four 90* corners . #2 1912 to 1920 rear cross member now has finder supports as part of the rear cross member and has cast running board brackets as the 09/12s . #3 1920 to 1925 there is no longer the three holes for the cast running board brackets in the frame , there is now a hole at the top of the frame were the cast holes had been on the sides . #4 1926 TO 1927 . Much larger rear cross member , the hand brake quadrant now has two holes in stead of the four that had been used before . There will be only two holes were this bracket goes . Some of the most telling things to look for .


Top of pagePrevious messageNext messageBottom of page Link to this message  By Perry Goble on Friday, June 23, 2017 - 02:38 pm:

I should have said body supports .


Top of pagePrevious messageNext messageBottom of page Link to this message  By Bill Everett on Friday, June 23, 2017 - 08:56 pm:

Thank you, Erie and Perry.


Add a Message


This is a private posting area. Only registered users and moderators may post messages here.
Username:  
Password:

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration