Blackhawk 4 In One Hand Crank Rim Wrench Number 5104 Patented 1928

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Classifieds: Blackhawk 4 In One Hand Crank Rim Wrench Number 5104 Patented 1928
Top of pagePrevious messageNext messageBottom of page Link to this message  By Jay - In Northern California on Tuesday, May 22, 2018 - 11:55 am:

Sockets slide and lock in place. Asking $70 plus postage.}


Top of pagePrevious messageNext messageBottom of page Link to this message  By Allan Bennett - Australia on Wednesday, May 23, 2018 - 07:30 am:

Jay, the speedbrace works well to run nuts up, but the short throw makes adding tension difficult. Can the handle be used on the side, acting as a long handle to do the final tighten? I have a Snap-on 1/2 drive speedbrace which takes ordinary sockets, and being able to crank it side ways at the end of running up the nuts, is a real boon, both setting the nuts and breaking them to run them off.

Allan from down under.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Jay - In Northern California on Wednesday, May 23, 2018 - 01:32 pm:

Allan, I have no problem getting the rim nuts God's tight with this tool. Jay


Add a Message


This is a private posting area. Only registered users and moderators may post messages here.
Username:  
Password:

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration