FS Speedster Intake Manifold and Header Plate Parts

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Classifieds: FS Speedster Intake Manifold and Header Plate Parts
Top of pagePrevious messageNext messageBottom of page Link to this message  By Mark Chaffin......Corona, CA on Friday, November 09, 2018 - 12:47 pm:

We previously listed Model T header plates, gaskets, and carburetor flanges for use when building a speedster exhaust and intake setup for your speedster. Upon doing so, we were asked if we could make a few intake manifolds like those used on our RAJO cylinder head. You can purchase the complete kit or individual kits to go with the header plate and gasket previously purchased. We also still have a few remaining header plates, gaskets, an carburetor flanges available individually like before. Supplies are very limited. This was a special small run. Purchase them while you can. Payment by PayPal (preferred) or check. PM me or call Mark Chaffin (951) 805-0928.


Complete kit with everything shown $295.00 plus $18.65 domestic flat rate shipping.



Kit #1 Intake manifold, gaskets and mounting hardware for use with our exhaust header plate. For use with a Winfield M201B carburetor or Carter BB1 $175.00 plus $13.65 domestic flat rate shipping.



Kit #2 Riser pipe, carburetor mounting flanges, gaskets, and mounting hardware. Trim pipe to length and install flanges in desired orientation. This was designed to work with our manifold $55.00 plus $13.65 domestic flat rate shipping.



INDIVIDUAL PARTS OFFERED


Model T Header Plate and Gasket. Polish grind finish to ensure they are flat. 3/8" thickness
Exhaust ports are 1 5/8" counter bored to accept standard 1 5/8" pipe. Intake ports measure 1 3/8"
$65.00 plus $13.65 domestic flat rate shipping.



Carburetor Mounting Flange. Polish grind finish to ensure they are flat. 3/8" thickness 1 5/8" counter bored to accept standard 1 5/8" pipe. Mounting holes are 3/8" and 2 15/16" center to center. Profile is for a Winfield Model M201B or Carter BB1. Price is $20.00 each plus $7.50 domestic shipping.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Mark Chaffin......Corona, CA on Friday, November 09, 2018 - 12:58 pm:

A few pics showing what the kit looks like installed. You build your headers to your liking. :-)





Top of pagePrevious messageNext messageBottom of page Link to this message  By Mark Chaffin......Corona, CA on Saturday, November 10, 2018 - 12:44 am:

One complete set sold to Bill. Thanks Bill! Thanks MTFCA!


Add a Message


This is a private posting area. Only registered users and moderators may post messages here.
Username:  
Password:

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration