Am working on a 1923 Tudor in which the mag has been removed and now runs on a distributor. The wiring harness has bad and will be replaced. Am wondering if there is a wiring harness for this application or just use the one vendors sell for cars with a mag and just tie off wires not used.
It might be simpler to use the stock wiring harness but there's extra wires and then there's the mods. If you're handy at wiring, your car would have a much cleaner look to the engine compartment if you made one. It's really not that hard. One end goes here, the other end goes there. Snyders sells braided wire and loom materials. Look in the Model A section.