Holly carburetor float setting

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2014: Holly carburetor float setting
Top of pagePrevious messageNext messageBottom of page Link to this message  By Gary Defosse on Friday, March 07, 2014 - 08:22 pm:

I just completed putting a gasket set and a new float valve in an NH carb. The float appears to be set at too much of an angle. Can anyone tell me what the proper setting is.
Thanks,
Gary


Top of pagePrevious messageNext messageBottom of page Link to this message  By Bob Jablonski on Friday, March 07, 2014 - 08:29 pm:

15/64th's measured directly opposite ( 180 degrees ) from the inlet valve


Top of pagePrevious messageNext messageBottom of page Link to this message  By Jim Patrick on Friday, March 07, 2014 - 09:56 pm:


Top of pagePrevious messageNext messageBottom of page Link to this message  By Gary Defosse on Saturday, March 08, 2014 - 06:14 am:

Bob and Jim,
Thank you very much.
Gary


Posting is currently disabled in this topic. Contact your discussion moderator for more information.
Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration