I placed an add in the classified, but I know a lot of you guy don't see them from day to day.
I'm looking for a rear hub puller for WIRE wheels ( not the standards pullers for rear hubs.
If any of you have on in stock to sell, please drop me a private message.
Thanks!
Michael
At one time,I had four of them They are very difficult to find, I believe The suppliers sell a repop.
Not hard to make one, if you have a spare axle nut, weld a flat plate of about 1" or so square to it, screw it on, nip it tight making sure you have some clearance between nut and hub, jack up the other side so the wheel clears the ground, leave the one you want off on the ground, and give the nut a smack with large or sledge hammer and that should crack the hub off the axle.
I haven't seen a repop one yet.
they look like this: