4th.main/ball cap eng. drawing/blueprint

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2014: 4th.main/ball cap eng. drawing/blueprint
Top of pagePrevious messageNext messageBottom of page Link to this message  By Steve Husa on Thursday, July 10, 2014 - 02:24 pm:

I am interested in making fixture to Babbitt/bore ball caps.

I think that I should start with a eng. drawing or blueprint of the part in question.

Does Ford offer a service of eng. drawings?

Thanks in advance for all your help!


Top of pagePrevious messageNext messageBottom of page Link to this message  By Jerry VanOoteghem on Thursday, July 10, 2014 - 04:18 pm:

Steve,

The Benson Ford Research Center can help you, http://www.thehenryford.org/research/researchLibrary.aspx


Top of pagePrevious messageNext messageBottom of page Link to this message  By Jerry VanOoteghem on Thursday, July 10, 2014 - 04:19 pm:

More specifically: http://www.thehenryford.org/research/partsDrawings.aspx


Top of pagePrevious messageNext messageBottom of page Link to this message  By Bob Shirley on Thursday, July 10, 2014 - 07:21 pm:

I have always cleaned and polished the tail shaft, making it undersize, and then bore the Babbitt to fit.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Bob Shirley on Thursday, July 10, 2014 - 07:26 pm:

Two separate fixtures.


Posting is currently disabled in this topic. Contact your discussion moderator for more information.
Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration