ID required for cam gear cover

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2014: ID required for cam gear cover
Top of pagePrevious messageNext messageBottom of page Link to this message  By Andrew Heffey NZ on Saturday, August 30, 2014 - 07:23 am:

I have a friend that has this cam gear cover but it's a little unusual. It has a bearing shell cast into one side which is on an angle, so that any shaft could not be driven off the crank pulley as it would be miles out of line. Can anyone explain what this cover would drive or could be used for. Thanks Andrew


Top of pagePrevious messageNext messageBottom of page Link to this message  By Les Schubert on Saturday, August 30, 2014 - 10:29 am:

Andrew
I have one of those too I believe it was for a accessory starter. I have never seen the rest of it. So this just my best guess. Maybe Jay can tell us


Top of pagePrevious messageNext messageBottom of page Link to this message  By Andrew Heffey NZ on Wednesday, September 03, 2014 - 05:19 am:

Thanks Les, does anyone else have any information what the the accessory would be used with this cover?


Posting is currently disabled in this topic. Contact your discussion moderator for more information.
Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration