Measurement needed

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2014: Measurement needed
Top of pagePrevious messageNext messageBottom of page Link to this message  By Steve Jelf, Parkerfield KS on Wednesday, September 17, 2014 - 03:50 pm:

I don't have a new drive shaft bushing handy. Can somebody give me the width of the face?


Top of pagePrevious messageNext messageBottom of page Link to this message  By John Haynes on Wednesday, September 17, 2014 - 08:06 pm:

I don't have a new one, but one that I have removed, the face has a diameter of 1.566. Do you mean the thickness of the face?


Top of pagePrevious messageNext messageBottom of page Link to this message  By Dan Treace, North FL on Wednesday, September 17, 2014 - 08:33 pm:

Steve

As John says, the 'width' across the diameter is 1.565" on a new repro.

The thickness of the flange is .168". About the same as the worn one, 'cept the worn babbitt bushing had an upset ridge on the outer edge, to about .180" or so, caused by univ-joint wear on the bushing.


Posting is currently disabled in this topic. Contact your discussion moderator for more information.
Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration