Thrust pin replacement

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2014: Thrust pin replacement
Top of pagePrevious messageNext messageBottom of page Link to this message  By Bill Elliott on Friday, November 07, 2014 - 03:36 pm:

I need to replace one of the thrust pins in the axle housing and need to know what size drill bit to use to put a new one in?


Top of pagePrevious messageNext messageBottom of page Link to this message  By Jack Daron - Brownsburg IN on Friday, November 07, 2014 - 05:23 pm:

Just drill a small hole as close to the center and screw in a metal screw.Then a claw hammer will pop it right out. Your new one will fit right in.


Top of pagePrevious messageNext messageBottom of page Link to this message  By joe bell on Friday, November 07, 2014 - 07:12 pm:

I drill them and tap them, when you run, I use allen bolt, down in hole it jacks the old one out.


Posting is currently disabled in this topic. Contact your discussion moderator for more information.
Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration