T-3402 Clutch shaft not like all the rest, any ideas

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2015: T-3402 Clutch shaft not like all the rest, any ideas
Top of pagePrevious messageNext messageBottom of page Link to this message  By ROBERT BERGSTADT on Friday, January 30, 2015 - 10:22 am:

I just found this clutch shaft but notice no holes 2 notches and 2 keyways, anyone know what this one fits,Bob
I do not have any ideas seen them before but getting a senior moment Bob


Top of pagePrevious messageNext messageBottom of page Link to this message  By Roger Karlsson, southern Sweden on Friday, January 30, 2015 - 10:30 am:

Here is a thread discussing an early clamp on style clutch fork: http://www.mtfca.com/discus/messages/257047/317177.html?1350297672

I think an early clamped on clutch fork with two screws would fit on your shaft.


Top of pagePrevious messageNext messageBottom of page Link to this message  By R.V. Anderson on Friday, January 30, 2015 - 11:03 am:

Roger is correct. This part was used from later 1909 into 1914. My August '14 uses it but I can't say with certainty that it's correct. I think Ford changed to the rivet-pin type during '14. It's sure a lot easier to install and remove than the pinned type.


Posting is currently disabled in this topic. Contact your discussion moderator for more information.
Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration