Fender Irons Bent?

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2015: Fender Irons Bent?
Top of pagePrevious messageNext messageBottom of page Link to this message  By Gary H. White - Sheridan, MI on Monday, March 02, 2015 - 06:27 pm:

Is there a way of checking if a fender iron is bent other than eye balling it? What is the best method of bending it back to original condition?


Top of pagePrevious messageNext messageBottom of page Link to this message  By Ken Kopsky, Lytle TX on Monday, March 02, 2015 - 07:30 pm:

I think the riser is supposed to be 49.5 degrees, IIRC.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Jack Daron - Brownsburg IN on Monday, March 02, 2015 - 07:50 pm:

Get the frame level and measure from floor to the irons,both front and rear. Once you get them right,then dry fit fenders. You at least get the same amount of sag on both sides of car. I use heat and then repaint irons. YMMV.


Posting is currently disabled in this topic. Contact your discussion moderator for more information.
Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration