Tightening sequence

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2015: Tightening sequence
Top of pagePrevious messageNext messageBottom of page Link to this message  By John Leffler on Tuesday, July 14, 2015 - 08:03 pm:

Just an off hand question. Is there a correct tightening sequence for an exhaust, carburetor manifold?


Top of pagePrevious messageNext messageBottom of page Link to this message  By Stephen D Heatherly on Tuesday, July 14, 2015 - 08:58 pm:

John, not really. Just snug the nuts down gradually then tighten them at the end.

Stephen


Top of pagePrevious messageNext messageBottom of page Link to this message  By Jack Daron - Brownsburg IN on Tuesday, July 14, 2015 - 09:06 pm:

I use a 6 inch box end and tighten them as tight a
as I can with one hand. After you run it, retighten again. Repeat as necessary for 3-4 times.


Posting is currently disabled in this topic. Contact your discussion moderator for more information.
Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration