Hogshead clearance issue

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2016: Hogshead clearance issue
Top of pagePrevious messageNext messageBottom of page Link to this message  By Donnie Dingler, Crowley Texas on Saturday, January 16, 2016 - 06:52 pm:

1924 Touring, car has wide brake drum. Removed/rebuilt rear end. While rear end was out removed hogshead for band replacement. Reinstalled rear end/drive shaft. Replaced trans bands. Trying to install hogshead having clearance issue.
Should have reinstalled hogshead before rear end due to ears on hogshead? Obviously I have a mix of parts due to large brake drum. Any suggestions?


Top of pagePrevious messageNext messageBottom of page Link to this message  By Mark Gregush Portland Oregon on Saturday, January 16, 2016 - 06:57 pm:

Back off the two bolts at the bottom of the ball cap and allow it and 4th to tip or move back a little.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Ken Todd, ............Red Deer, Alberta on Saturday, January 16, 2016 - 08:46 pm:

"ears on hogshead"

Are you saying that it's an '26-'27 hogshead?
Does it have a 3 dip or 4 dip pan?
If it came apart it should go back together.
Try Mark's suggestion.


Add a Message


This is a private posting area. Only registered users and moderators may post messages here.
Username:  
Password:

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration