Making a new throttle shaft

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2016: Making a new throttle shaft
Top of pagePrevious messageNext messageBottom of page Link to this message  By Richard Gould, Folsom, CA on Friday, July 08, 2016 - 09:09 pm:

Just finished making a throttle shaft for a 5 ball carburetor. I used a slotting saw to make the slot in the shaft. Also used no 43 drill and 4 40 taps for the screws. I used the old shaft as a guide to drill and tap the screw holes, so I could re use the butterfly disc. It came out good and was easier than I imagined.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Royce in Dallas TX on Friday, July 08, 2016 - 09:49 pm:

Nice work Richard !


Top of pagePrevious messageNext messageBottom of page Link to this message  By Larry Smith, Lomita, California on Friday, July 08, 2016 - 09:56 pm:

Richard, you da man!


Add a Message


This is a private posting area. Only registered users and moderators may post messages here.
Username:  
Password:

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration