Crank pulley runout

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2016: Crank pulley runout
Top of pagePrevious messageNext messageBottom of page Link to this message  By Steve Jelf, Parkerfield KS on Thursday, September 01, 2016 - 10:19 am:

The engine from my 1923 touring, currently undergoing a rebuild, needs a better crank pulley. So I'm checking several possible replacements.


This one has .010" run out. I suspect that's good enough, but I'll check a few others.

Is measuring this a bit of overkill?
:-)


Top of pagePrevious messageNext messageBottom of page Link to this message  By Verne Shirk on Thursday, September 01, 2016 - 11:00 am:

I chucked my crankshaft/pulley in the lathe and made sure there was no runout.


Add a Message


This is a private posting area. Only registered users and moderators may post messages here.
Username:  
Password:

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration