Where should the horn wire go through bulkhead

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2017: Where should the horn wire go through bulkhead
Top of pagePrevious messageNext messageBottom of page Link to this message  By Robert Blanchard on Tuesday, March 07, 2017 - 07:01 pm:

I have a Klaxon on my 1920 T and currently the wires from the horn run under the bulkhead/firewall and into the engine compartment. Is there a specific place these wires are supposed to go through? There is a hole marked in the picture... is this where its supposed to run through?

Thanks in advance for any help!


Top of pagePrevious messageNext messageBottom of page Link to this message  By Allan Bennett - Australia on Tuesday, March 07, 2017 - 09:12 pm:

Robert, a correct T battery horn has just one wire. I run mine up the firewall on the loom clips you already have and then it goes through the firewall with the wires for the switch loom.

hope this helps.
Allan from down under.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Bill Harper - Keene, NH on Tuesday, March 07, 2017 - 10:35 pm:

Hi Robert,

The hole you indicate is where the magneto post wire passes through on this 1922 firewall:



The horn wire passed through this hole which I do not see on your firewall.




I hope that this helps. Good luck with your project. Bill


Add a Message


This is a private posting area. Only registered users and moderators may post messages here.
Username:  
Password:

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration