Muncie aux

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2017: Muncie aux
Top of pagePrevious messageNext messageBottom of page Link to this message  By Randall Strickland, Lambsburg Va on Thursday, October 05, 2017 - 07:18 am:

What couplers are needed to install Muncie aux trans?
Thanks


Top of pagePrevious messageNext messageBottom of page Link to this message  By Kurt Baltrusch on Thursday, October 05, 2017 - 10:10 am:

Randall - The Muncies had a coupling sleeve (round on the outside, square on the inside) that fit over the Model T transmission output shaft . I can get dimensions for you if this is what you are talking about. You might be able to find a piece of heavy wall square tubing that would do the same thing.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Randy Brown - Austin, Texas on Thursday, October 05, 2017 - 11:00 am:

Randall,
For my Muncie, I cut a piece off an old transmission tail shaft for my coupling. The result was a perfect fit.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Henry Petrino in Modesto, CA on Thursday, October 05, 2017 - 11:28 am:

1. To "couple" the T output to the Muncie input a special u-joint is used that has a shortened female end. This is a Muncie part originally provided with the Muncie. Some folks have custom made a male/female coupler for this connection and it seems to work out fine.

2. To "couple" the Muncie output to the drive shaft a simple coupler is used. It looks like a piece of round stock, maybe around 1.25" in diameter, with a square hole its entire length. This is a Muncie part originally provided with the transmission.

I hope this helps you.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Randall Strickland, Lambsburg Va on Thursday, October 05, 2017 - 12:08 pm:

Thanks fellows Iím going to try Randyís way I have an old tail shaft, I have an old warlord in my touring how do the Muncie compare as being quitter or noisier and underdrive , overdrive to the warlord?


Top of pagePrevious messageNext messageBottom of page Link to this message  By Erik Barrett in Auburn Ca. on Thursday, October 05, 2017 - 01:23 pm:

Muncie is noisier, especially in OD.


Add a Message


This is a private posting area. Only registered users and moderators may post messages here.
Username:  
Password:

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration