Thread size of needle seat

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2009: Thread size of needle seat
Top of pagePrevious messageNext messageBottom of page Link to this message  By Simon Bayley on Monday, December 14, 2009 - 05:08 am:

Hi

I was wondering if anyone knew the thread size on the seat on a holley nh carb - I had to drill one out by now need to re thread it.

Simon


Top of pagePrevious messageNext messageBottom of page Link to this message  By Anthonie Boer on Monday, December 14, 2009 - 06:05 am:

Simon ;
The thread of the seat is: 1/4 x 32 NEF .
I always heat the carb. till the area around
the outside of the seat just start to red hot,
and then put them in water, then you can turn the
seat out whith a small screwdriver
greetings Toon


Add a Message


This is a private posting area. Only registered users and moderators may post messages here.
Username:  
Password:

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration