In search of measurements

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2018: In search of measurements
Top of pagePrevious messageNext messageBottom of page Link to this message  By Tom Tuominen on Wednesday, January 03, 2018 - 08:35 am:

Does anyone have the dimensional drawings for the spring/perch bushings for the one ton trucks. I need to fabricate these bushings for a customer's truck. Thanks.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Tom van der Vyver on Monday, January 29, 2018 - 02:12 am:

Are you talking about the rear bushings?


Top of pagePrevious messageNext messageBottom of page Link to this message  By Jerry VanOoteghem S.E. Michigan on Monday, January 29, 2018 - 11:22 am:

All you need is 3 dimensions. Measure the inside diameter of the perch/spring, the outside diameter of the hanger pin, and the width of the perch/spring. Make the O.D. of the bushing about .001 bigger than the hole it's pressing into, the I.D. about .005 bigger than the hanger pin diameter, and the length to match the width of the perch/spring.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Mark Gregush Portland Oregon on Monday, January 29, 2018 - 12:34 pm:

Or call Lang's. There was just another posting in Dec about same thing.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Adrian Whiteman, New Zealand on Monday, January 29, 2018 - 05:20 pm:

Front perch bushes are same as a T car.
Rears are larger but easily available from T parts suppliers.


Add a Message


This is a private posting area. Only registered users and moderators may post messages here.
Username:  
Password:

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration