Need a little help

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2018: Need a little help
Top of pagePrevious messageNext messageBottom of page Link to this message  By Spencer Vibert - Granby ,CT on Monday, February 12, 2018 - 06:42 pm:

Ok guys this one is for the books while line boring a block with my kr Wilson rig one of the set screws backed out a and kicked one of the cutters deep in the block and snapped one of the cutters flush with the boring bar so my question is Does any one have a extra cutter they would part with If a picture is needed I can remove one of the remaining cutters thanks


Top of pagePrevious messageNext messageBottom of page Link to this message  By Steve Hughes, Raymond, NE on Tuesday, February 13, 2018 - 02:41 pm:

Pull one of the other cutters and measure up the dimensions. Then get a hss blank and grind a new cutter to match. Shouldn't be too hard to do.


Top of pagePrevious messageNext messageBottom of page Link to this message  By James A Bartsch on Tuesday, February 13, 2018 - 03:18 pm:

Spencer: Grizzly has decent prices on assorted HSS blanks, here are some examples, good luck.

http://www.grizzly.com/search?q=(hss+AND+square)+OR+(hss+OR+square)


Add a Message


This is a private posting area. Only registered users and moderators may post messages here.
Username:  
Password:

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration