Bronse thrust washer id

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2018: Bronse thrust washer id
Top of pagePrevious messageNext messageBottom of page Link to this message  By Philip Thompson Graham NC on Wednesday, February 14, 2018 - 01:55 pm:

i made a set of bronze thrust washers to the od and id of a good intact babbitt one i found the id is about .05 bigger than the hub it fits on the carrier
is this correct or should i make new ones. philip


Top of pagePrevious messageNext messageBottom of page Link to this message  By Hal Davis-SE Georgia on Wednesday, February 14, 2018 - 03:56 pm:

Those hubs on the carrier are often worn.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Mark Gregush Portland Oregon on Wednesday, February 14, 2018 - 07:20 pm:

What ID did you make them, someone can check a new one to see what it is. Don't forget to add a way to get lube in. Some just have slots along the face others have a cast in spiral.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Philip Thompson Graham NC on Wednesday, February 14, 2018 - 07:58 pm:

I made them 3.75 x 2.34 x .20 I got those dims
From an intact babbitt one. Philip


Top of pagePrevious messageNext messageBottom of page Link to this message  By Dean Dorholt - Mpls, MN on Wednesday, February 14, 2018 - 09:41 pm:

New Bronze one right out of the package,
ID 2.32
OD 3.752
Thick .192


Add a Message


This is a private posting area. Only registered users and moderators may post messages here.
Username:  
Password:

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration