????????? on Ford Tool # 3X3223

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2018: ????????? on Ford Tool # 3X3223
Top of pagePrevious messageNext messageBottom of page Link to this message  By Bill Crosby Webster, NY on Wednesday, February 28, 2018 - 11:19 pm:

Does any one know what a Ford tool # 3Z3223 looks like? any Dimensions, Pictures or Information would be helpful.

Thank you
Bill


Top of pagePrevious messageNext messageBottom of page Link to this message  By Steve Jelf, Parkerfield KS on Thursday, March 01, 2018 - 12:10 am:

Are you sure about that number? I don't find anything like it on the Ford tool list.

application/pdf
Model T Tools All.pdf (50.7 k)


Top of pagePrevious messageNext messageBottom of page Link to this message  By Larry Smith, Lomita, California on Thursday, March 01, 2018 - 12:12 am:

Sometimes the numbers on the tools aren't too clear. It most likely is something close.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Bill Crosby Webster, NY on Thursday, March 01, 2018 - 01:09 am:

I got the number from the Model T Ford Service Bulletins by Murray Fahnestock Page 125 about the Carburetor Float.

The number stated is 3Z-3223 bending tool.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Mark Gregush Portland Oregon on Thursday, March 01, 2018 - 02:22 am:

Might be the tool shown on page 209 fig 437 paragraph 885 in the Model T Ford Service book. It does not list a parts number and the picture is not that great. In Bruce's book The Model T Ford on page 605 a tool No 24Z-3990 Float gauge and adjusting tool is listed, (from Service Bulletins Nov 1 1919). On page 597, that tool number is listed; 3Z-3223, float seating tool (Holley carburetor, Service Bulletin, Nov 15, 1919. There are a number of other tools for carb work listed on those pages. No pictures.


Top of pagePrevious messageNext messageBottom of page Link to this message  By Mark Gregush Portland Oregon on Friday, March 02, 2018 - 09:40 am:

bump


Add a Message


This is a private posting area. Only registered users and moderators may post messages here.
Username:  
Password:

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration