|
|
|
By Paul Sherman Tacoma WA on Monday, March 05, 2018 - 01:40 pm:I have the M. Miller plans that I bought from Leon Parker. However, I have a problem. Somehow, the lower RH corner of Plate #8 is missing (I cut it off). can someone tell me if a drawing of the door corner block is on the lower RH corner of plate #8. And if so, can someone scan it and email it to me? montpaul@msn.com. I can make the part without the drawing, but my door rewooding is
a scan will help. I sent an email to Leon but he has not answered. So far my door rewooding is going fine.
Thank you, Paul in Tacoma
By Thomas Jull in Oakland on Monday, March 05, 2018 - 09:14 pm:I sent you an email with a photo attached of the corner block. Hope it helps.
By Paul Sherman Tacoma WA on Tuesday, March 06, 2018 - 12:42 pm:Thomas, thank you for the copy of the corner block. I will make a pattern, them fabricate the block. I am thinking of laminating (3) pcs. of 3/8" plywood together. I am a bit leery of cutting the deep slots on my table saw, so I will make the middle pc. in a profile where to slot areas are already in the sandwich. This may be hard to follow, but I think this is the safest way to make the corner block.
Paul in Tacoma
|
|