Manifold copper gasket measurements

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration
Model T Ford Forum: Forum 2018: Manifold copper gasket measurements
Top of pagePrevious messageNext messageBottom of page Link to this message  By Tom F on Friday, July 06, 2018 - 01:21 pm:

Hey guys. Can someone post up the measurements of the individual, crush type copper gaskets used on the manifold?

ID, OD, and thickness?

Apart from thickness, does the ID change at all once compressed?


Top of pagePrevious messageNext messageBottom of page Link to this message  By Steve Jelf, Parkerfield KS on Friday, July 06, 2018 - 01:55 pm:

No, it's around a steel ring so the ID can't compress. ID = 1". OD = 1".


Top of pagePrevious messageNext messageBottom of page Link to this message  By Mark Gregush Portland Oregon on Friday, July 06, 2018 - 06:50 pm:

Which type are you asking about? The ring and gland or the all copper type (with built in gland ring)?


Add a Message


This is a private posting area. Only registered users and moderators may post messages here.
Username:  
Password:

Topics Last Day Last Week Tree View    Getting Started Formatting Troubleshooting Program Credits    New Messages Keyword Search Contact Moderators Edit Profile Administration