What is the correct way to remove the inner front wheel bearing? The grease seal seems very tight in the hub. Is there a way of removal that I won't mess up the bearing? Thanks

A hit with a blunt tool works, drive in from the outer hub end. Wood dowel works well. Tap around the bearing a few places.... and the dust seal and bearing will fall out of the hub race.

I use one of these...

And you can buy one here:

https://www.amazon.com/Performance-Tool-W1219-Professional-Puller/dp/B000FW7W6S

I do as Dan does.Use the bearing as a pusher. Tap it out from the outside end of the hub with a drift of your choice. The seal will come with the bearing.
Little risk of damage to the seal that way.

Hope this helps.
Allan from down under.

And if you need a new seal...

I am assuming you have roller bearing?

I got them out with no problems by driving the bearing from the outboard side. Thanks for the replys.