Page 1 of 1
K R Wilson Oil Pan Straightening Jig
Posted: Wed Apr 22, 2020 12:55 am
by Dale_mcm
Would someone be kind enough to furnish me a blueprint or pdf file with all dimensions to make one of these.
Help would be appreciated. Thanks Dale
Re: K R Wilson Oil Pan Straightening Jig
Posted: Wed Apr 22, 2020 12:29 pm
by agriscience
Check with Jay Skinner in Long Beach CA.
562-426-5478 He collects paper and tools!
Re: K R Wilson Oil Pan Straightening Jig
Posted: Wed Apr 22, 2020 2:13 pm
by Dale_mcm
Contacted Jay nice fellow. Thanks Steven.
Re: K R Wilson Oil Pan Straightening Jig
Posted: Wed Apr 22, 2020 2:41 pm
by ChrisB
Could you post your findings for all to see please.
Re: K R Wilson Oil Pan Straightening Jig
Posted: Wed Apr 22, 2020 11:11 pm
by Allan
I have a cast iron engineers surface plate, and would appreciate a map of the pan bolt holes.
Allan from down under.
Re: K R Wilson Oil Pan Straightening Jig
Posted: Wed Apr 22, 2020 11:33 pm
by Kerry
Got a spare 26/27 block and hogs? then bolt the 2 together and trace the bolt pattern to the plate and for the few that can't be got at lay a gasket on to find them.
Myself. I wouldn't go through the trouble of making one for the few I check, just use the 26/27 block and hogs as is, a length of exhaust pipe for a centre line and not hard to ruler the ears, front and back to check for specs.
Re: K R Wilson Oil Pan Straightening Jig
Posted: Wed Apr 22, 2020 11:45 pm
by Steve Jelf
...bolt the 2 together and trace the bolt pattern to the plate...
Excellent. I love that idea. 
Re: K R Wilson Oil Pan Straightening Jig
Posted: Thu Apr 23, 2020 12:00 am
by Dale_mcm
Allan check the Jay Skinner lead posted above your post. Jay Skinner Thanks guys for all of the feedback
Dale