Page 1 of 1
bailing wire nut?
Posted: Tue Nov 10, 2020 8:17 am
by Mustang1964s
I ran across this front axle.
This is kind of scary, I just can think how things could have gone wrong.
bailing wire, talk about a field fix.
Re: bailing wire nut?
Posted: Tue Nov 10, 2020 11:56 am
by Dropacent
Bailing wire is the JB weld of the 1920’s and 30’s
Re: bailing wire nut?
Posted: Tue Nov 10, 2020 11:58 am
by Mark Osterman
I bet that car had a death wobble shimmy!
Re: bailing wire nut?
Posted: Tue Nov 10, 2020 12:28 pm
by JohnM
A temporary although questionable fix to get you where you're going. On the other hand, it was probably put on there before you were born and it's still there

Re: bailing wire nut?
Posted: Tue Nov 10, 2020 12:47 pm
by ThreePedalTapDancer
Re: bailing wire nut?
Posted: Tue Nov 10, 2020 1:04 pm
by JohnM
Dang It! Where did you get that picture of me!!!

Re: bailing wire nut?
Posted: Tue Nov 10, 2020 1:26 pm
by StevenS
The wire is probably all rusted up together tight, so ......... technically it is a rusted on nut.
I also think he, ......... "nailed it" ........ right as a good repair.
Re: bailing wire nut?
Posted: Tue Nov 10, 2020 1:29 pm
by Mark Gregush
Hay seed repair, but at least the cotter pin is in place even if it's a nail!

Re: bailing wire nut?
Posted: Tue Nov 10, 2020 1:53 pm
by Mustang1964s
I saw that and just had to post it.
Just when you think you have seen it all, then the Model T still surprises.
Re: bailing wire nut?
Posted: Tue Nov 10, 2020 8:40 pm
by CudaMan
Remember, there is nothing more permanent than a temporary fix that works!
