Lifting Flywheel
Posted: Wed Nov 18, 2020 8:49 pm
Page 1 of 1
this little tool, sure made setting coil ring a lot easier. The bolt locks in the hole in the shaft. No more strong arm lifting the flywheel.
Re: Lifting Flywheel
Posted: Wed Nov 18, 2020 9:03 pm
Very Nice!
Re: Lifting Flywheel
Posted: Thu Nov 19, 2020 8:39 am
Would it be possible to show just the tool? I have this project coming up.
Re: Lifting Flywheel
Posted: Thu Nov 19, 2020 11:28 am
This is a scrap of 2.25 cold roll about 1.75 long. Bored to 1.1 inch and drilled and taped for a 5/16 bolt. The loop is made from a flower arrangement holder that the local cemetery discards when the get a little rusty.
. Call if I can help, Bob at nine o 3-824-1949
Re: Lifting Flywheel
Posted: Thu Nov 19, 2020 1:29 pm
I saw this in an old Vintage Ford, I believe - quite simple to make & saves the old back !
Re: Lifting Flywheel
Posted: Thu Nov 19, 2020 7:26 pm
Thank you. It is more clear now, I just didn't see the hanger loup.
Re: Lifting Flywheel
Posted: Tue Nov 24, 2020 11:19 pm
We manufacture the Model T 3-Point transmission sling in the attached picture, which works great with any shop crane/engine lift. You need a sling that will lift both the transmission and the flywheel as a single assembly, like ours does. If interested, PM me for price and ship dates. Lots sell out quickly when released.
R/Mark, Wms MFG
R/Mark, Wms MFG
Re: Lifting Flywheel
Posted: Wed Nov 25, 2020 6:09 am
I easily made a flywheel lifting device like Steve posted. It’s really important to have 3 ‘legs’ of chain and hooks rather than 2. More stable.u