MTFCA Forum

Hey all,
I am looking to buy the hub thread chaser.
Number by Lang is 2815T, by Snyders T-2815-T.
Does any one out there know where I can buy one , on both places it is backorder and no date to be available again.

Thanks
Andre
Belgium

Andre,

I do not know if these are available in Belgium, but you might find a "thread file" that has the correct number of teeth for your needs. I have used thread files often and have had good luck with them in many applications. Each one has 8 different tooth sets, 4 on each end, so be sure the file you get has the thread count you need.

Good Luck,
Terry