MTFCA Forum

Folks - Only 8 weeks until the Mid Atlantic Prewar Swap Meet in Beautiful Luray, Virginia! We currently have almost 80 vendor sites sold which beats our all time high record for our spring meet - and we are closing in on the attendance we experienced at our "one-time-only" fall meet.

Use this thread to post what you will be bringing to sell. Looking forward to seeing you there!

Planning on bringing a trailer full of stuff. Dan

I will be bringing the Electronically Cranked Coil Tester (ECCT), Maintenance free Ideal Timer (I-Timer) and E-Timer. Will also be demonstrating coil testing and tuning using the ECCT. Looking forward to seeing everyone!

I will be bringing a new '23-'25 roadster top kit, '19- '22 turtle deck, '20's touring rear doors, vintage tools and other treasures.

I'll be baaaaccck! Bringing some brass lamps, misc pre-war lit, a selection of automobile sheet music, and some nice early automobilia you wouldn't usually see other than at Hershey including some rare spark plugs for collectors. Of course there will be some T stuff mixed in too. Looking forward to another great time at Luray.
Terry

Terry... looking forward to seeing you again!

I am bringing a pair of 23 - 25 Fordor rear fenders, a 1913 well used block and what I believe is a post 27, after production ended block to sell. May have a few 2-cylinder Maxwell parts too.

This will be at Luray if not sold before. Asking $15000.00. Can also be picked up at Luray Swap meet if needed. This car is listed in the classified section with more description.
Contact me if interested or want to arrange to see it.
540-860-1384

Here is picture of the trailer so far. Dan

Rebuilt rear ends, Winfield carbs, Chevy adapter plates, misc, etc, etc.

Hank

I just picked up two trailer loads of used parts. Most is 1917 to 1927. What are you in need of ? I will bring it along. Just a month away now !

Will have my rewound field coils, Watts style clutches, new correct wheel hub bolts and nuts, early wood coils and boxes, and a bunch of new items along with a good selection of the more than 210 reproduction parts that I make for the Model T and horseless carriages. Shipping costs are getting insane so come to Luray and save big!!!

Will have nice set of rear doors w/hinges/latches for '26-'27 touring, 13-14 brass radiator (a few leaks),'12 alum. hood, pair early front hubs with wide hub cap threads, set of four good 21" split rims, pair '26-'27 rear radius rods, and boxes of misc. T parts and pieces.

Looking for a useable pair of running boards, rough surface, but still straight ok, plus one driver's side running board with some rust pitted patina.

Terry_007 wrote: ↑

Sun Mar 21, 2021 11:24 pm

I'll be baaaaccck! Bringing some brass lamps, misc pre-war lit, a selection of automobile sheet music, and some nice early automobilia you wouldn't usually see other than at Hershey including some rare spark plugs for collectors. Of course there will be some T stuff mixed in too. Looking forward to another great time at Luray.
Terry

I'll be looking for ya!

Bringing 60_ different tools--see McCalleys book page 602. Missing only 2-3 tools from those pictured. New completely restored OF Carb by Stan Howe, m still in box as sent to me-. couple fenders 27 rear, + ?.., Boxes of T parts to look through. A real load of T parts. greg

I will be looking for a good set of early AC style small drum brakes.

If I make it I will bring my wife.

Should add, shes not for sale though.

Bob

Good one

Bringing the wife too, but Julia requested to be in charge of handling the sales collection.

That way she prevents my spending the proceeds on more “T stuff” , as she calls it.

Bring Stevens Front Axle Tooling and Inserts.
Also bringing some rebuilt front axles, two 26/27 and two 25 earlier.
Lots of other stuff too. Dan

We are nearing 60 vendors and I think we will have a great meet.
Looking forward to it!!!

Front door see post:
viewtopic.php?f=2&t=16667&p=126129#p126129

Seat Springs:
https://photos.app.goo.gl/Y21G3bDXi5UkCadh7

Air compressor pump head for Model A
Gordon Smith & Co. Bowling Green KY.
https://photos.app.goo.gl/Y21G3bDXi5UkCadh7

Steve Florence

Mostly '17-'22, low radiator shells, low hoods, splash aprons, '23 -'25 rear spare tire carriers. See you there

RV - Are you bringing floorboards?

Oh Snap! My Son's collage announced graduation ceremony; Yep 5/14! So will not be going to Luray this year unfortunately. Will miss seeing everyone. Have a safe and great time.

I’ll have my fenderless 26 speedster for sale. 26 engine w/ matching VA title in my name. Home built body by us. Big toolbox on the back nice round gas tank between the seat and box. Motor was gone through about a year and a half ago. Cylinders bored with new egge 0.040 over aluminum pistons, SS valves adjustable tappets. New exhaust manifold with new tail pipe and new stamped muffler(tack welded) New 4th main from gene French, rev Anderson mag ring with recharged magnets, jack rabbitt clutch and Texas t 12v alternator. 1930something Chevy wire wheels with new 475-500-19 universal tires, tubes and flaps. Rebuilt small drum axle(wheels don’t fit over a large drum) . New thrust washers, thrust pins, bearing sleeves, neoprene inner and outer seals, accessory relined parking brake shoes. New rear shackle shackle bushings. New bushings in front spring shackles and spindle arms. New water pump. Radiator doesn’t leak a d cools well with the pump. Starter works as it should and has a new bendix spring and hardware on a good original bendix. Wired for 12v lights and turn signals. Replaced the brake quadrant, ratchet pawl and springs. Parking brakes adjusted and functioning properly. Good set of Kevlar bands. Runs and drives as it should. Pictures will be available as soon as I dig my crap out from around it. Price will be $4500 or best offer. Feel free to call/ text or email anytime at bkirtner(AT)gmail.com and 54zero761two303

Brad

I will have For Sale, Model T parts in general and the following:

* 1912 Model T Torpedo Runabout, "Southern Wide Track", had it there last year and will bring it again in hopes finding a good home. Old restoration and
some parts not correct, but would make someone a fun little car.

* 1916 Engine w/Alum. Transmission Cover.

* 1915 and 1916 Engine Blocks.

* 1933 Ford Glove Box Radio with trim cover, been restored internally with great sound.

Thanks for looking.
Jim Suter

Dan: My brother is bringing floorboards, top bows, and some body wood pieces. He's the wood guy. Call him at 7 one 6/nine eight five/five 880 or his cell at 7 one 6/four 99/seven two 55.

Bring an assortment of T Parts, Curved Dash Olds Parts & a few NRS Ford parts. Also have extra Chairs so stop in and rest your footies!!!!

See you soon Bob.
Terry

I have a pair of 24/25 coupe rear fenders available. I can bring to Luray if someone is interested. Just posted on the parts side of the forum. Here is the link with photos and asking price:

viewtopic.php?f=5&t=21072

A trailer full plus!!!!!

We will be bringing a pickup load of parts over the mountain. Rear fenders, running boards, firewalls, splash apron(1), set of tin can pistons and x-rods, misc. brackets, Stromberg LB-2 and OF, Heinze Coil box w/coils, 6 1/2" dropped axle w/conn.rod, rear axle lowering brackets, spindles w and w/o arms, bucket of misc. T era tools. Non-T parts include, Fordson coil box body, Fordson Zenith carb., 1927 Chevy Quota Trophy, pair of large car leather jump seats, Model A rods, early crank, horn parts and whatever else we can load up.

Plus, I will have information on a 1927 Model T Roadster Pickup and 1931 Model A Vicky Coupe that are for sale.

Thanks,
Howard

I plan on being there Friday morning, at a friend’s spot, with a couple of brass windshields, maybe a couple of other odds and ends. Got up real early this morning and filled Suburban up with gas, this town has little traffic at 5 in the morning! David Coco Winchester Va.