MTFCA Forum

Does anyone have a pattern for the Gypsy Curtains for a 1926-27 Roadster?

I found some good pictures on this forum but not a pattern with dimensions.
Thanks

...for me too, please.

If you can wait a couple weeks I have a set coming from Car. I would measure and post results unless someone beats me to it

Thanks for the offer. I will wait to hear from you.
Dennis

Let me know if you need anything else. I don’t know much as I just got them and haven’t even held them up to the car yet.

Thanks for posting these pictures. I did not see these until this morning. Can you measure one of the angles?? I am very rusty on my geometry.
Thanks
Dennis

DontKnowMuch wrote: ↑

Mon May 31, 2021 11:48 am

Thanks for posting these pictures. I did not see these until this morning. Can you measure one of the angles?? I am very rusty on my geometry.
Thanks
Dennis

If you get the exact measurements of the inner triangle you can use this link to calculate the angles. Since the width of the each frame piece forms parallel lines the outer triangle would have the same angles. All the pictures with the tape measure need to be more accurate. https://www.calculator.net/triangle-cal ... &x=68&y=23
Here is an example:

Make a template from cardboard first.

I will measure the angles as non are right angles to start with