MTFCA Forum

This manifold came with the 1917 two piece crankschaft engine.
Does any know where it was used??

I had one before but it was cracked, this one is in fine condition.

Thanks
Andre
Belgium

Andre, that is a manifold for a heater.
All the little dimples are screws for a shroud that goes over it and directs hot air to the floorboard.
I have one too, with no shroud the same as yours.

That's correct. It is for a heater. If you use a heater, be sure there are no exhaust leaks or you could bet carbon monoxide poisoning.
Norm

Some pictures of it in use

Thanks All,

Great information.

Andre
Belgium