Page 1 of 1
KRW tool to ID please
Posted: Mon Aug 30, 2021 7:03 pm
by Ruxstel24
I have this tool/cutter. I can’t tell if it 6060 or 6050 B-1. Cutter and a jig. What’s it for ?
Re: KRW tool to ID please
Posted: Mon Aug 30, 2021 7:44 pm
by Pep C Strebeck
For cutting valve clearance into the cylinder heads that have been milled (flat heads), 6050-B-1. I believe that the B-1 suffix would make it later V-8, and if it were just the B suffix it would be earlier, but do not quote me on that.
Re: KRW tool to ID please
Posted: Mon Aug 30, 2021 8:47 pm
by Ruxstel24
Pep C Strebeck wrote: ↑Mon Aug 30, 2021 7:44 pm
For cutting valve clearance into the cylinder heads that have been milled (flat heads), 6050-B-1. I believe that the B-1 suffix would make it later V-8, and if it were just the B suffix it would be earlier, but do not quote me on that.
Thanks Joe ! Doubtful that anyone would mill a T head that far anyway.

Re: KRW tool to ID please
Posted: Tue Aug 31, 2021 7:05 am
by Jim Eubanks
It is a V8 tool. Want to part with it?
Re: KRW tool to ID please
Posted: Tue Aug 31, 2021 7:06 am
by Jim Eubanks
It is a v
V8 tool, want to part with it?
Re: KRW tool to ID please
Posted: Tue Aug 31, 2021 7:17 am
by Ruxstel24
Jim Eubanks wrote: ↑Tue Aug 31, 2021 7:06 am
It is a v
V8 tool, want to part with it?
I will, make me a reasonable offer...send me an email, hpautorepairdd at Gmail dot com
Re: KRW tool to ID please
Posted: Tue Aug 31, 2021 8:33 am
by Ruxstel24
Sorry Jim, Mr Prus beat ya to it.
Re: KRW tool to ID please
Posted: Tue Aug 31, 2021 9:14 pm
by Cordes_jeff
Tool for cutting valve relief in prewar heads when put on postwar blocks.