Found this manifold mixed in with an A heater manifold. It lines up with the ports on a T block.
Looks like a zoom zoom updraft carburetor would fit.
Simmons intake manifold...A or T ?
Forum rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
-
- Posts: 3678
- Joined: Sun Jan 06, 2019 3:13 pm
- First Name: Wayne
- Last Name: Sheldon
- * REQUIRED* Type and Year of Model Ts owned: 1915 Runabout 1913 Speedster
- Location: Grass Valley California, USA
- Board Member Since: 2005
Re: Simmons intake manifold...A or T ?
That is a model A version. However, the spacing is right. And with a little effort it could be used on a model T!
-
- Posts: 1361
- Joined: Thu Jan 10, 2019 3:54 pm
- First Name: Kevin
- Last Name: Pharis
- Location: Sacramento CA
Re: Simmons intake manifold...A or T ?
Sure looks model A to me. The port flange shape and the exhaust manifold heat exchanger bolt holes are the give away. The A intake port spacing is sumpin like 1/16” wider than a T too
-
Topic author - Posts: 2345
- Joined: Sun Jan 06, 2019 11:25 am
- First Name: Dave
- Last Name: Hanlon
- * REQUIRED* Type and Year of Model Ts owned: 24 Touring car
- Location: NE Ohio
- MTFCA Number: 50191
- Board Member Since: 2018
Re: Simmons intake manifold...A or T ?
Thank you !
I think it’s a possibility for a speedster.
I think it’s a possibility for a speedster.
-
- Posts: 6435
- Joined: Sun Jan 06, 2019 11:18 am
- First Name: Scott
- Last Name: Conger
- * REQUIRED* Type and Year of Model Ts owned: '13, '15, '19, '23
- Location: Clark, WY
- Board Member Since: 2005
Re: Simmons intake manifold...A or T ?
it is one of a 2 piece system (exhaust manifold) for a Swan Carb. That one is not for a T. I have one in my collection because it is quite unusual. Little info about them other than their battles with several car manufacturers over patent infringements
A little info and a couple pix here: http://www.mtfca.com/discus/messages/118802/123671.html
A little info and a couple pix here: http://www.mtfca.com/discus/messages/118802/123671.html
Scott Conger
Tyranny under the guise of law is still Tyranny
NH Full Flow Float Valves
Obsolete carburetor parts manufactured
Tyranny under the guise of law is still Tyranny
NH Full Flow Float Valves
Obsolete carburetor parts manufactured
-
Topic author - Posts: 2345
- Joined: Sun Jan 06, 2019 11:25 am
- First Name: Dave
- Last Name: Hanlon
- * REQUIRED* Type and Year of Model Ts owned: 24 Touring car
- Location: NE Ohio
- MTFCA Number: 50191
- Board Member Since: 2018
Re: Simmons intake manifold...A or T ?
Scott, I think I have the exhaust manifold too.
It has a piece broke off of one of the ports.
I see the carb mounting holes are 90deg from the T manifold....thanks for the link.
It has a piece broke off of one of the ports.
I see the carb mounting holes are 90deg from the T manifold....thanks for the link.