Page 1 of 1
Miller head update
Posted: Mon Oct 11, 2021 10:28 am
by Model T Tom
Re: Miller head update
Posted: Mon Oct 11, 2021 1:17 pm
by TXGOAT2
Is it iron or aluminum?
Re: Miller head update
Posted: Mon Oct 11, 2021 1:46 pm
by Scott_Conger
Tom
as I previously said, I was skeptical, and as I followed up before, now I'm just humbled. Very, very nice pattern work, and exemplary foundry work.
Re: Miller head update
Posted: Mon Oct 11, 2021 3:21 pm
by CraneJon
Tom
Did not see you in Hershey
Jon
Re: Miller head update
Posted: Mon Oct 11, 2021 6:46 pm
by Model T Tom
This is iron but will be available in aluminum as well. Testing soon
Re: Miller head update
Posted: Mon Oct 11, 2021 6:58 pm
by TXGOAT2
What type chamber and about what compression would be obtained with stock pistons (or others)?
Re: Miller head update
Posted: Wed Oct 13, 2021 9:09 am
by Model T Tom
The chamber is a crow foot design . Compression is 6.25 with stock pistons.
Re: Miller head update
Posted: Wed Oct 13, 2021 10:16 am
by TXGOAT2
Interesting.....
Re: Miller head update
Posted: Wed Oct 13, 2021 10:51 pm
by ModelTWoods
Tom, If the heads test good, and you're still taking orders, put me down for an IRON head. I sent you an email, but hadn't got a reply.
Re: Miller head update
Posted: Thu Oct 14, 2021 6:36 am
by Model T Tom
After testing I will be taking orders .
Re: Miller head update
Posted: Thu Oct 14, 2021 9:05 am
by ModelTWoods
Model T Tom wrote: ↑Thu Oct 14, 2021 6:36 am
After testing I will be taking orders .
Thanks, Tom. I, and many others, I'm sure, will be waiting.
Re: Miller head update
Posted: Fri Oct 15, 2021 12:24 pm
by BHarper
I am keenly interested in your project and hope that the testing goes well.