MTFCA Forum

I have this pump that I just installed a rebuild kit in. I am missing the fitting on the base to connect the hose to. Does anyone know where to get one?

What year is your pump, or what year car is your pump going with? There were several different styles. I have the drawings for all of them; they are simple enough that you could make your own.

I apologize; I misread your post. I thought you were looking for the clamp that secures the hose to the fitting. Stupid.

I believe I have a loose original with the check valve. Tmorsher@icloud.com and I’ll look

I should have some too just need to know what thread size you require.

Hank

I got this pump to go with my '26 touring. Probably not correct with the brass body but I like it. I tried to determine the size. First glance just figured 1/8" pipe, but way smaller than that. 1/4" fine slips in, 5/16" too big. Got it in my mind that it might be the same size as a valve stem. Acts like wants to start in but doesn't. Threads may be dinged but I didn't want to go too far until I knew for sure.

Will take a look tomorrow.

Hank

Gator,

I found a few in my odd box, closest one is a 5/16” x 24 NFT with a check valve. I do have one only of the odd 9/32” x 32 NFT with no check valve. $12.00 each plus shipping.

Let me know,

Hank