MTFCA Forum

So in a moment of silly I have embarked on another part reproduction project!!
This bracket bolts to the front fender arm and can fit either side. Typically it was on the drivers side. I’m currently obtaining costs and as is typical the more copies I make, the lower the unit cost will be. If you are interested, please respond.
The next project will be making new Canadian brake lights. That will be a REALLY entertaining project!!

Interested

Hello Les: Put me down as insterested in the "Front License Bracket" POPS

Hi Les,
I too would be interested in the design / location. I have been seeking an alternative
location for my Number Plate for ages. Currently it sits behind the crank handle and is almost non visible
as I have front bumper bars too. Maybe the Geelong models were different again and I should look at the
original car here in Perth. I’m about to locate it in a wooden board in the centre of the bumper bars.
Regards Alan

Hello Les, Unfortunately we missed contact last summer on our camping trip tour through Calgary. Thank you for first of all for your ability to design and make these parts that improve our cars, and more importantly, your interest and willingness to create them. I am building a car like yours and would certainly be honored to have one of those brackets, and a floating transmission shaft, and probably anything else you make for this car. Again my gratitude.

Ken
Thank you for the kind words.
So I will probably make 10 copies. Hopefully in a couple of weeks

Can you post a picture of it?

Well adding the pictures is easier than on the old forum!!!

With the Bracket being located there certainly encourages hand cranking from the bottom up only!
Alan

Alan
The edge of the plate is about at the edge of the radiator core. So clear of the crank

And of course well behind it too

I also would like one for my 26. Please add me for one on your list Eck

Put me down for 2 please Les

Hi Les

I am also interested in at least 6 when it happens.
Curious to know more about the possible brake light project also

Many thanks
Glen McConachie
Dunedin
New Zealand

So now it looks like at least 20 pieces.
I’ll be getting the parts laser cut and I’m pursuing finding a local supplier with a spot welder to put the parts together

Am I too late to put my name in for one? My current front plate mounting is destroying my radiator, may as well do it right.

No problem

Hi Les, Put me down for one also. On Canadian cars, should the hole in front fender support already be there? Thanks jw

Yes it uses the existing front upper bolt

These should be ready tomorrow. If you are interested please contact me
Thank you

Les, how much do they cost, how much for shipping, and how do you want to get payment.

I think that it will probably work out to $30.00 with shipping. I have not had a chance to confirm this though, just a guess!!

Les, I would like a bracket, I sent you a email via this system with my email contact. If you didn't get it; kmatt at netptc dot net

[imae][/image]

So here they are, all done!!

Looks great !! Thank you. This is the first time I have got on the forem in a week or so and not sure how I did it. Just let me know where and amount to send and it will be on your way. Did not find personal message , just your mail message. Keep getting Torgan message and stops my progress. Thanks again for your hard work. Eck

Checked shipping cost and yes $30.00 US total price to the USA.
I will accept PayPal, or check or cash.
My mailing address is 100-182028 174 Ave West, Foothills AB T1S 2B8, Canada

Do you have a total cost for us Canucks, Les?

check is in the mail Thanks Eck

check is in the mail, Thanks jw

Hi Les, Just wanted to thank you for the WOW new license bracket. Thanks again. jw

I got mine and it looks great! Thanks for investing the time, $$$, and energy into the project.