Angle Brass Molding for Framing Early Floorboards. Where can I buy it?
Posted: Sun Jul 17, 2022 10:58 pm
-
Hello fellow Model T-ers.
My 1912 Warren Speedster lost one of its fancy brass framed floorboards on Interstate 5 somewhere between Los Angeles and San Francisco. So, unless I see it laying on the highway tomorrow when I drive back south, I will need to fabricate a new one. Would any of you know where I might get my hands on the approximately 3/4" X 1/4" brass angle molding that frames these panels? I have had no luck with Google.
Thank you in advance for any leads you may have.
Hello fellow Model T-ers.
My 1912 Warren Speedster lost one of its fancy brass framed floorboards on Interstate 5 somewhere between Los Angeles and San Francisco. So, unless I see it laying on the highway tomorrow when I drive back south, I will need to fabricate a new one. Would any of you know where I might get my hands on the approximately 3/4" X 1/4" brass angle molding that frames these panels? I have had no luck with Google.
Thank you in advance for any leads you may have.